Publicité
Les langues disponibles
Les langues disponibles
5. Function of keys
Reset: Stop measuring / Reset the applied program
Print: Printing function
Run: Start measuring
Spindle: Rotor selection (maximum viscosity value measured depending on the
selected speed)
Speed: selection of rotating seed
Series 807
↑
: Increase speed value
↓
: Decrease speed value
→
: Go to next digit (during speed selection)
←
: Back to previous digit (during speed selection)
6. Description of displayed data
Series 807
20.0 ºC
20.0 ºC: Temperature measured by the temperatura probe in ºC
SP: Number of selected rotor (e.g. SP 4 means selection of rotor nº 4)
60.0 RPM: Rotating speed of motor in RPM
888888.8 mPa·s: Maximum viscosity measured at the selected rotating speed and
with the selected rotor in mPa•s.
45.7 %: Percentage of measurement or wresting square. Its value must be
between 20% and 90%; if it is out of this range, it will be necessary to change the
rotating speed and the rotor since the selected ones are not adequate for the
viscosity of the liquid to be analyzed.
60.0 RPM
45.7%
SP 4
888888.8
mPa·s
6
Publicité
