Publicité
Les langues disponibles
Les langues disponibles
3. Supplied items
(1)
Digital viscosimeter
(2)
Ascending and falling rack
(3)
Base
(4)
Rotors ( No.1,2,3,4)
(5)
Rotor protective fram
(6)
Temperature probe (Series 807)
(7)
Power adapter
(8)
Spanner
(9)
Screw driver
4. Installation (Please refer to the installing chart)
(1)
Take the base, the ascending and falling rack, the main body of
viscosimeter, the rotors and the protective frame out from the case.
(2)
Put the ascending and falling rack into the hole of both parts of the base
so as the opening direction of the base and the upper rack face user; the
tighten firmly the M12 nut with the supplied spanner.
(3)
By turning the knob of the ascending and falling rack check that the clamp
moves up and down easily; if movement is too loosen or tighten, then
adjust the M4 screw at the back by using the screw driver supplied. It is
recommended that the screw is firmly tighten so as avoiding the
viscosimeter to fall down during operation
(4)
Install the viscosimeter body on the clamp of the ascending and falling
rack and hold it firmly with the tightening bolt. Check that the rotor joint
screw is well protected with the yellow cap (always put this cap in case of
transporting the equipment or if it is not going to be used for a long time).
(5)
Adjust the two leveling feet so as the equipment is well leveled (the level
bubble at the upper part of equipment must be well centered).
(6)
Connect the temperatura probe.
(7)
Make sure that the switch is in off position and connect the equipment to
the main supply through the adapter.
Rotor
5
Publicité
