Please Note Before Heating For The First Time; Igniting; Combustion Air Slide Valve; Regulation Of Combustion Air - Olsberg Tolima PowerSystem II Compact Instructions

Please note before heating for the first time

● Remove all accessories from the ash pan and com-
bustion chamber.
● The odour given off by the evaporation of the pro-
tective coating disappears after the stove has been
burning for several hours (ventilate the room well).
● The stove has a high quality temperature resistant
coat, which does not achieve its final strength un-
til the stove has been heated for the first time. You
should therefore never leave anything on the stove
and not touch the surfaces as the paint coat could
otherwise be damaged.
● As soon as the kindling material has burned down,
put on 2 burnouts consisting of 3 kg wood ensuring
that the temperature resistant coating reaches its fi-
nal firmness.

Igniting

● Before ignition, check that no flammable objects are
placed on the stove.
● Empty the ash pan if necessary and slide back in.
● Open the combustion air slide valve complete.
● Grate in open position = operating lever pulled out
● Stack small amounts of firewood and, on top of it,
kindling material (ignition cubes and dry, smaller ig-
nition wood) and ignite it.
● Close the door to the combustion chamber so that
the kindling material can catch fire.
● Once there is a basic firebed, add more fuel accord-
ing to the heat requirement (see chapter "Heating").
Caution:
When heating up the fireplace, difficulties in igniting the
firewood can occur if a flue draught has not yet formed
in the chimney, and ventilation devices/systems are op-
erated at the same time. In this case briefly opening a
window in the installation room or temporarily switching
off the ventilation system can help.

Combustion air slide valve

Operating lever for combustion air supply
CLOSED
● Operating lever on CLOSED:
all slide valves closed
● Operating lever on 1/2 OPEN:
Secondary air slide valve completely open /
Primary air slide valve completely closed
● Operating lever on OPEN:
Secondary air slide valve completely open /
Primary air slide valve completely open

Regulation of combustion air

Position of operating lever:
OPEN ......... Ignition position, max. heat output
1/2 OPEN ... Nominal heat output with billet wood
1/2 OPEN ... Nominal heat output with wood briquettes
CLOSED ..... Obtain glow
● As the secondary air also contributes to the cleanli-
ness of the glass pane, the operating lever should be
set on "1/2 OPEN" minimum. This also applies in the
event of low-load operation.
● When not operating the lever should be set on
"CLOSED", to reduce the cooling down of the room.
OPEN
17