Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
4. MEMORY +12V
5. AUTO ANTENNA OUTPUT
6.
7. +12V (TO IGNITION KEY)
8. GROUND
Note: 12 V wire (connector A no. 7) must be connected by car ignition key in order to avoid
that car battery becomes weak when the car will be not used for long period.
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
Maintenance
FUSE REPLACEMENT
If the fuse blows, check the power connecton and replace the fuse. If the fuse blows again
after the replacement, there may be an internal malfunction. In this case, consult your
nearest repairing centre.
Warning
Use the specified amperage fuse for each lead. Use of a higher amperage fuse may cause
serious damage.
OPERATING INSTRUCTIONS
POWER ON/OFF (1) (PWR)
Push Power button in order to switch on the unit. Push PWR button newly in order to switch
off the unit and push REL button (14) to release the front panel.
Note: Never release the front panel when the unit is on. Power remains on even when car
radio is off.
SELECT (2) / VOLUME UP/DOWN (3)
English
5
Rotate the VOLUME Knob (3) to control the VOLUME. To select other functions, press the
SELECT (2) button shortly until the desired functions is shown on the display. Figure 1
shows how control functions are selected using the SELECT button.
1. VOLUME (rotate knob)
2. SELECT (push down)
3. BASS
4. TREBLE
5. BALANCE
6. FADER
7. LOUDNESS ON / OFF
8. EQUALIZER (ROCK - POP - CLASS - SDP OFF)
9. DX / LOC
10. STEREO / MONO

- VOLUME CONTROL

-
- AMS (AUTOMATIC PRESET STATION (5)
-
-
-
6
English
Rotate the VOLUME knob to increase or decrease the volume. This knob can be used to
adjust the BASS, TREBLE, BALANCE and FADER.
This knob also selects the possible options in RDS function.
PRESET STATIONS (1,2,3,4,5,6) (4)
(A) RADIO MODE:
When pressed short, these keys select a preset station directly. When pressed longer
than 1 sec., current station is stored in preset memory bank.
When pressed, the strongest radio stations are stored in sequence to the memory of
the unit.
EQUALIZER BUTTON (6)
Press in sequence this button to change the Equalizer preset.
PLAY / PAUSE BUTTON (7)
Press this button to Play or put in Pause the MP3 song when reproduced by USB or SD.
DISPLAY BUTTON (8)
When this key is pressed, it is operated as the conversion of each display mode.

Publicité

Table des Matières
loading

Table des Matières