Load Label Roll In Tear-Off Mode - Valentin SPECTRA II Guide De Référence Rapide

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
Spectra II

Load Label Roll in Tear-off Mode

I
H
G
F
E
Open the printer cover.
Open the printhead (G) by turning the pressure lever (H) anticlockwise.
Spectra 216:
Pull the centring plate (I) outwardly.
Remove the outside label mounting plate (A).
Load the label roll with inner winding onto the unwinding roll (B) and attach again the label mounting plate (A).
Lead the label material below the label guiding (D).
Pay attention that the label runs through the photocell (E).
Spectra 216:
Lift the centring plate (I) again upwards.
In order to move the printhead (G) down, turn the pressure lever (H) in clockwise direction until it locks.
The tear off edge (F) is visible in front of the printhead.
Enter the offset value in the menu Print settings/Tear off.
Adjust the limit stops (C) of the label guiding to the width of material.
Close the printer cover.
62
English
A
B
C
D

Publicité

Table des Matières
loading

Table des Matières