Zero PORTA Mode D'emploi page 8

zero
ZPORTAV230|CONTROL PANEL | PORTA 230 V
HOME AUTOMATION
CONFIGURATION
DIPPERS FUNCTION - OPERATIN TIME
DIP 1 ON
Enables automatic closing timer.
DIP 1 OFF
Disables the automatic closing
OPERATION TIME
DIP 2 ON
Enables programing operation time
DIP 2 ON and DIP1 OFF
Programming operation time.
DIP 2 ON and DIP1 ON
Programming the closing time
DIP 2 OFF
Disables programing closing time
PROGRAMMING VIA RADIO
DIP 3 ON
Radio programming new transmitters enabled
DIP 3 OFF
Radio programming disabled
DEAD MAN FUNCTION
DIP 4 ON
(ENABLED) To achieve closure, you must hold down the
transmitter button or the alternate button. If you do not
hold down the command of stops.
DIP 4 OFF
(DISABLED) Nnormal operation mode.
SAFETY DEVICE CONFIGURATION
DIP 5 ON and DIP 6 ON
Photocels and safety edg DISABLED
DIP 5 ON and DIP 6 OFF
Photocels and safety edg ENABLED
DIP 5 OFF and DIP 6 ON
Photocels and safety edg 8.2KOhm ENABLED
DIP 5 OFF and DIP 6 OFF
Photocels ENABLED safety edg 8.2KOhm DISABLED
PG8
TRANSMMITERS CONFIGURATION
Storing codes Transmitters
To store the codes of the transmitters, the control panel
must be in stable condition and the door stops.
Manual store
To store the code press the button PROG until the audible
indicator is active. The red LED lights up, and when the
button is released, the LED remains on, indicating that the
unit is ready to store the transmitter code. From now on
any received code will be stored. So we will press on the
transmitter function with which we want to activate the
automatism. The red LED and accompanied by the acustic
beep indicator, start flashing confirming us the execution
of storage. After 10 seconds elapsed since the last recep-
tion of a code the device will automatically leave the me-
mory function by switching off the red LED and emitting
two short beeps.
Erasing all Codes
The cancellation of all codes is obtained by the "reset" of
the memory. Press PROG for 6 seconds. It will produce a
flurry of red flashing lights and a short beep indicating the
cancellation of all previously stored codes. The device will
remain in the storage sequence of pending codes of new
memorize.
PROGRAMMING REMOTE CONTROLS WITHOUT ACCESS
TO THE CONTROL BOARD (HIDDEN BUTTON)
Using an already configured TRANSMITTER:
Press transmitter's hidden keys simultaneously for 1 sec
while red LED flahs and acustic beep indicator is on.
Press the new transmitter's desired opening key while led
and acustic indicator signs the transmitters storage.
After 2 seconds elapsed since the last reception of a code
the device will automatically leave the memory function
by switching off the red LED and emitting two short beeps.
OPTION (configuration with brake relese PORTA SB)
BRAKE TRANSMITTER RELEASE
To use this function it is necessary to:
A - have previously programmed a code of a transmitter
with hidden key.
B - have connected the two electric brake cables to the
terminals 12 and 13, respecting the polarity.
C - have connected the 12V battery (1,2Ah-7Ah) to the
terminal 14 and 15 respecting the polarities.