Orion ORLASER104 Manuel De L'utilisateur page 2

ORLASER104 Back Panel
1 – AC Input
2 – Power Switch
3 – Cooling Fan
4 – Audio Sensitivity Knob
5 – DIP Switches
6 – DMX Signal Indicator
7 ‐ XLR DMX/Link Input / Output
Standalone Operation
Set dipswitches (see chart) to either Sound Active or Auto Mode and power up unit. After brief reset
the unit will begin to operate. In Auto mode, the ORLASER104 will run randomly though its pattern
presets. There is no laser off in auto mode.
In Sound Active mode, unit will respond to music at the microphone input and activate. Set sensitivity
to ensure unit is active to music source only as desired. The unit will step though its presets in response
to audio source and shut off when no music is present.
Master / Slave Operation
Up to 32 units can be linked to operate in unison without a controller. Choose a master unit and set
dipswitch to either Auto or Sound Active mode. Set subsequent units in 'Slave' mode and use standard
XLR cable to link.
DMX Operation
Set units to run in DMX (Slave) Mode and assign a channel using the DMX Quick Reference Chart
included in this manual.