Attaching The Dimmers; Important; Installing The Power Cord - sobro SOSTB300 Manuel D'utilisation

Attaching the Dimmers

The Sobro comes with two attachable Dimmers in
the same container as the legs of the table. These
attach to the back of the Sobro and allow you to
adjust the brightness of the Back Light manually.
Both Dimmers function the same way, so control of
the Back Light is always within reach.
18 ∙ attaching the dimmers
Sobro Side Table Manual_Eng-Fr_V1.indd 18-19 Sobro Side Table Manual_Eng-Fr_V1.indd 18-19
To attach the Dimmers, simply slide them
onto the small metal rods on the back of
the Sobro. Your Sobro's Back Light is now
ready to use!
1
Attach the Power Supply Cord to the table.
Warning: Do not attempt to install the Power
Cord until the legs are installed.

Installing the Power Cord

2
Lift up your table and carefully place it down on its legs
and then attach the Power Supply Cord to the wall.

Important:

This appliance must be plugged into a
grounded socket. The power cord that is supplied
with the appliance contains the appropriate
grounding conductor and grounding plug. The plug
must be inserted into a wall outlet that has been
grounded in accordance with the existing local codes
and ordinances. The required nominal voltage and
frequency are indicated on the rating label. Consult
a qualified electrician for other concerns. We do not
recommend plugging the Sobro into a power strip.
installing the power cord ∙ 19
3/4/20 5:32 PM 3/4/20 5:32 PM