Functional Description And Specifications - Bosch PS90 Consignes De Fonctionnement/Sécurité

BM 2610012409 02-11:BM 2610012409 02-11 2/7/11 7:14 AM Page 6

Functional Description and Specifications

IMAGER CABLE
Optical Cable Length: 4' (17mm diameter) included with PS90
ImAgER CABLE ASSEmBLy
To use the Product, the imager cable must be
attached to the handheld display unit. To
connect the cable, make sure the key and slot
are properly aligned. Once they are aligned,
finger-tighten the knurled knob to hold the
connector in place.
SLOT
FIG. 2
IMAGER HEAD
IMAGER CABLE CONNECTOR
3' (9.5mm diameter) included with PS91
Assembly
The three included accessories, (mirror, hook
and magnet) attach to the imager head in the
same way. To connect, hold the imager head,
slip the semicircle end of the accessory over
the flats of the imager head, then rotate the
accessory a 1/4 turn so the long arm of the
accessory is extending out.Always direct the
cord toward the rear, and away from the shear.
Keep it away from sharp edges.
FIG. 3
KEY
-6-
LED
CAMERA
MIRROR
TO INSTALL AN ACCESSORy
MAGNET
HOOK
FIG. 4