BM 2610012409 02-11:BM 2610012409 02-11 2/7/11 7:14 AM Page 2
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install
in accordance with the manufacturer's
instructions.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful
interference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE! This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
U.S. Patents 7,384,308; 7,431,619 B2; 7,581,988 B2; 7,584,534; 7,758,495 B2; other patents
pending.
Industrial Designs and other patents pending
Perceptron is a registered trademark of Perceptron, Inc. © 2010 Perceptron, Inc. All Rights
Reserved.
Perceptron, Inc., 47827 Halyard Dr., Plymouth, MI 48170. www.perceptron.com
Important Safety Instructions
FCC Statement
-2-
8) Only use attachments/accessories specified
by the manufacturer.
9) Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way,
such as power-supply cord or plug is
damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does
not operate normally, or has been dropped.
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
• Use of shielded cable is required to comply
with Class B limits in Subpart B of Part 15
of the FCC rules.
• Do not make any changes or modifications
to the equipment unless otherwise specified
in the manual. If such changes or
modifications should be made, you could
be required to stop operation of the
equipment.