ewo GOURMET BASIC Instructions De Montage page 16

Installation instructions GOURMET PREMIUM 3-Way
Despite simple Assembly they should only installed by technically savvy Persons.
1. Close the water supply at the corner valves under your sink
2. Open Cold and hot water lines on your faucet (pressure release)
3. Demount the current flex-tube from the cold water angle valve on the wall (KW)
4. Screw the EWO vitalizing module (No.2) on the outcome of the Filter housing
(No.1) - take care for the seal!
5. Mount the short flex-tube (No.7) to the angle valve under your sink (cold water)
and on the other side the T-piece adapter (No.8)
6. Demont your current faucet. Then screw on the new faucet the 3 attached,
short tubes. Install now the whole new faucet
7. Connect the cold water input of the new faucet
with the T-piece adapter (No.8) and the
remaining, third outlet of the T-piece with
the pipe (No.5) on the filter housing
8. Mount the tube (No.6) at the output of the EWO VITAL device and connect it
with the double nipple (No.9) to the input of the 3-way faucet (the middle
input for filtered water)
9. Connect the warm water input (left input) with the angle valve on the wall
10. Attach the filter housing bracket (No.3) with the woodscrews at a suitable place
under your sink and screw the filter housing on it
11. Open the corner valves under the sink and check the installation for leakprofeness
12. Open breather-screw (No.11) on top of filter housing shortly to eliminate
a possibly existing Air cushion
13. Flush the cartridge a few minutes to activate it
sight from
bottom up
16