Product Description; Taking Into Use; Functions - Trotec BX11 Manuel D'utilisation

PRODUCT DESCRIPTION

Operating keys
Plug
LCD display

TAKING INTO USE

Place three AAA R03/1. 5V into your energy meter before you connect
it to an electrical consumer. In order to do so, first loosen the screw to
the battery compartment and then remove the lid. Make sure that the
battery poles are properly aligned. Be sure to screw the lid securely
into place again before actually taking your energy meter into use!
m
The display is now activated and can be configured accordingly.
Please remember that these settings will be deleted when the
batteries are exhausted or when the batteries have been remo-
ved from the battery compartment when not connected to the
mains. To insert/replace the batteries, the device must not be
connected to the power supply! There is a risk of electric shock!
B - 3
Batteries
Plug
Operating manual – Energy cost measuring instrument
Degrees of contamination
The following are the degrees of contamination as specified according
to IEC 664:
- Degree of contamination 1
No or only dry non-conductive contamination.
- Degree of contamination 2
Dry, non-conductive contamination only. Occasional temporary con-
ductivity through dewing must be reckoned with.
- Degree of contamination 3
Conductive contamination or dry, non-conductive contamination
which can become conductive can occur because of expected dewing.
- Degree of contamination 4
Contamination leads to consistent contamination because of conduc-
tive dust, rain or snow.

Functions

• Display
- time (24h) and day
- current energy consumption (W) and electricity frequency
- voltage, amperage and total recording time
- total energy consumption (kWh) and resulting costs
• Two programmable electricity tariffs
• Overload alarm and reset function
EN