Operating Peripheral Equipment; Programming The Remote Control Code - Panasonic TH-42PX500U Mode D'emploi

Operating peripheral equipment

Programming the remote control code

You can operate other manufacturers' components using this TV's remote control.
Preparations:
• Connect the power cord of the external component to the wall outlet.
• Make sure the component is turned off.
POWER
SAP
LIGHT
TV VCR DVD
DTV RCVR DBS/CBL AUX
TV/VIDEO SLEEP EXIT
CH
+
-
VOL OK VOL
CH
MENU RETURN
TVGUIDE INFO PAGE
1 2 3
4 5 6
7 8 9
R-TUNE PROG
0
REW PLAY FF
PAUSE REC
STOP
SPLIT SWAP
TV/VCR OPEN/CLOSE
DVD/VCR CH
TV
1
CH
POWER
+
- +
VOL OK VOL
CH
2 VCR DVD
RCVR DBS/CBL AUX
3
1 2 3
4 5 6
7 8 9
0
Notes:
• If the component does not operate with the remote control, repeat the procedure
using another code. (Some brands have multiple codes.)
• If an incorrect code is entered, or if the procedure takes longer than 30 seconds, the
programming will fail.
To find a code not listed in the index
1
After selecting the type of component (step 2, above)
CH
- +
VOL OK VOL
CH
2
CH
+
-
VOL OK VOL
CH
Press and hold POWER and
least 5 seconds.
• The mode selection buttons flashes, and then release
POWER and key.
OK
Select the type of the component.
• The selected button lights and all others go out.
Enter the 3-digit infrared code (see pages 54-55).
• Factory default setting : Panasonic
• Press POWER to test the operation.
Press to select the code.
• The code starts from the current device.
• Press POWER button to test the operation.
• Repeat the steps until the component code is found.
It may take many attempts before the correct code is
found.
Press to store the code.
key together, for at
OK
53 53