Panasonic TH-42PX500U Mode D'emploi page 26

Menu Navigation
PC Adjust
Press to select "PC Adjust".
CH
Press to display the PC Adjust screen.
+
-
VOL OK VOL
CH
During "RGB / PC" input signal.
PC Adjust 1/2
Normal
Sync On G
Dot Clock
H-Position
V-Position
PC Adjust 2/2
Clock Phase
Input Resolution VGA
H-Frequency 48.6 kHz
V-Frequency 60.3 Hz
26
Sync
• H & V : The H and V sync signals are input from the HD/VD connector.
No
• On G : Uses a synchronized signal on the Video G signal, which is input from the G
connector.
0
0
Dot Clock
0
Alleviates the problem if a picture appears to be vertically-striped, flickers partially
or is blurred.
H-Position
Adjust the horizontal position.
V-Position
Adjust the vertical position.
Clock Phase
Alleviates the problem if the whole picture appears to flicker or is blurred.
0
First adjust the Dot Clock to get as good a picture as possible, then adjust the
Clock Phase so that a clear picture appears.
Note : It may not be possible to display a clear picture due to poor input signals.
Input Resolution
Switches to wide display.
Input signal switched from VGA to WVGA
Input signal switched from XGA to WXGA
H-Frequency/V-Frequency
(Displays the frequencies of the PC signal currently being adjusted.)
Displays the H (Horizontal)/V (Vertical) frequencies.
Display range: Horizontal
Picture 1/2
Normal
Pic. mode Standard
Picture
Brightness
Color
Tint
Sharpness
CH
- +
VOL OK VOL
CH
CH
- +
VOL OK VOL
CH
15 - 110 kHz
Vertical 48 - 120 Hz
Picture 2/2
No Color Temp
Color Mng.
+30 C.A.T.S
0 Zoom Adjust
0 PC Adjust
0 Other Adjust
+10
Cool
Off
Off