GoECOlife nanocut OPTIMUS GHC85P-BLK Instructions D'installation page 9

operation (cont'd)
To Put Back Into Auto Mode:
7. Press the green GoECO
and when you insert papers into the paper throat, the shredder will
start automatically.
For Paper Jams:
8. If you insert more than the maximum number of paper sheets allowed and jamming
occurs, the machine will automatically go into reverse to push out the jammed papers.
To Turn Off:
9. There are 2 ways to stop the shredder where all power to the shredder will be shut off.
This also cuts off any phantom load power leakage.
a. Toggle the power switch on the top panel of the shredder to "OFF".
b. Or, do nothing, and the GoECO
Door Open:
10. When the doors are open or ajar, the shredder will not start until the doors are
completely closed.
Overheating:
11. During long periods of continuous shredding, the shredder's temperature will rise. When
the temperature reaches the maximum allowed level, the shredder will automatically
shut off the motor until it has cooled to an acceptable temperature. The shredder will be
ready to resume paper shredding when the motor has sufficiently cooled.
Paperclips And Staples:
IMPORTANT!
12.
small paperclips, industrial or non-standard size staples, jumbo and/or butterfly
paperclips, or binder clips. ONLY paper can be inserted to be shredded, otherwise
damage will be caused to the blades.
button on the control panel. The shredder is now in AUTO mode,
®
technology will turn off automatically if left idle.
®
This shredder should NEVER shred anything made of metal: staples,