Operating Instructions; Overview; Installation / Fixture; Connecting The Fan Heater - APA 27101 Manuel De L'opérateur

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

1. Outlet opening
2. Mounting foot, rotatable
3. Air inlet
4. Connection cable with 12 V
vehicle connector
Figure 1: Overview

6.2 INSTALLATION / FIXTURE

Look for a suitable location in your vehicle to position the
fan heater. The xture surface must be smooth and even (no
grained surfaces). Pay attention to the appropriate points in
the safety precautions (section 4). Clean the surface and the
underside of the xture pedestal to remove dust and grease.
Pull the protective lm from one side of the adhesive strip
(Position 7 in the overview). Place the adhesive strip onto the
xture pedestal, with the adhesive surface on the bottom,
Position 7 in the overview) and push rmly into place, see
Figure 2.
Now remove the other protective lm of the adhesive strip.
Place the fan heater in the cleaned spot in your vehicle and
press rmly into place.
Figure 2: Mounting adhesive strips

6.3 CONNECTING THE FAN HEATER

Lay the connection cable so that you are not obstructed when
driving. Check that the switch (position 5 in the overview) is in
the „0" position, see Fig. 3. Insert the plug of the connection
cable (position 4 in the overview) into the 12 V vehicle socket.
6
5. Switch
6. Hinge
7. Adhesive strip
The fan heater is now ready for operation.
Position „0"
Figure 3: Switch position „0"

6.4 OPERATION

Only operate the fan heater when driving or when
the motor is running, otherwise there is a risk that
the battery of your vehicle may be discharged.
Using the switch you can choose between two modes:
Position I: Fan
Position II: Fan with heating
You can switch the device o by bringing the switch to the „0"
position.

7. TROUBLE SHOOTING

Problem Possible cause
The fan The connector has
heater not been inserted
is not correctly into the
working vehicle socket.
With some vehicles,
power is only
supplied to the
vehicle socket when
when the ignition
is switched on and/
or the engine is
running.
The fuse of the
vehicle socket has
blown.
The fuse in the car
plug has blown.
The solution
Pull the connector
out of the socket and
insert again.
Switch on the ignition
and start the engine.
Replace the fuse
belonging to the
vehicle socket.
Replace the fuse
for the car socket.
Section 7.1