Sears Kenmore 110.66132 410 Guide D'utilisation Et D'entretien page 7

TIMED CYCLES –
Will run the dryer for the specified time on the control.
Settings shown and options in bold are default settings for that cycle.
Items to dry: Cycle:
Any load Timed Dry
Any load Touch Up
Small loads and Express
sportswear (2 to
3 items)
*Depending on settings, steam option may be disabled to protect clothing and optimize performance.
STEAM CYCLE –
Designed for use with dry loads to loosen wrinkles, reduce odors, and refresh fabrics.
Settings shown and options in bold are default settings for that cycle.
Not all settings and options are available on each cycle.
Items to dry: Cycle:
Mixed loads Steam
Refresh
Select a drying temperature based on the fabrics in your load.
If you are unsure of the temperature to select for a load, select
the lower setting rather than the higher setting.
Temperature Tips
A High heat setting may be used for drying heavyweight
n
items such as towels and work clothes.
A Medium to Medium High heat setting may be used
n
for drying medium-weight items such as sheets, blouses,
dresses, underwear, permanent press fabrics, and some
knits.
CYCLE GUIDE – TIMED CYCLES
Default Available
Time: Options:
40 Wrinkle Guard™*
Cycle Signal
20 Wrinkle Guard™*
Cycle Signal
15 Wrinkle Guard™*
Cycle Signal
CYCLE GUIDE – STEAM CYCLE
Dry Temp: Dry Level:
N/A
Setting the Dry Temp
Select a drying temperature based on the fabrics in your
load. If you are unsure of the temperature to select for a
load, select the lower setting rather than the higher setting.
Use this cycle to quickly refresh an item or remove light
wrinkles. The load is cooled slowly to reduce wrinkling and
make it easier to handle.
For small loads of 2-3 items.
Available
Options:
Wrinkle Guard™ Use to smooth out wrinkles and reduce
Cycle Signal odors from loads consisting of 2 to 4
dry items of wrinkle-free cotton, cotton-
polyester blend, common knits, and
synthetic garments.
A Low heat setting may be used for drying lightweight
n
items such as lingerie.
Use an Air (no heat) setting for foam, rubber, plastic,
n
or heat-sensitive fabrics.
Line dry bonded or laminated fabrics.
n
NOTE: If you have questions about drying temperatures
for various loads, refer to the care label directions.
Cycle Details:
Cycle Details:
7