PRONIVO 205-DGTA-5 Manuel D'instructions page 6

Thank you for purchasing the Electronic Digital Transit/Theodolite. Please read this
manual thoroughly before operation
MODEL
205-DGTA-5 5 Sec. Electronic Digital Transit/Theodolite
EN
205-DGTA-2 2 Sec. Electronic Digital Transit/Theodolite
Copyright© 2011 proNIVO Messgeräte Handels GmbH
The information contained herein is proprietary information of proNIVO, and is subject to
change without notice.
This document shall not be copied or otherwise reproduced without proNIVO written consent.
FEATURES FIG.1
1 Targeting Sight
2 Objective Lens
3 Horizontal Clamp Knob
4 Horizontal Tangent Screw
5 Display Window
6 Operation Keys
7 Leveling Screws
8 Instrument Center Mark
9 Optical Plummet
10 Tripod Base Plate
CALIBRATION
h T s i q u l a y t i p o r N V I
factory. The instrument has also been given the best protection possible against damage during
transportation. Even with these precautions, the instrument is subject to rough handling during
shipment. To protect yourself against the possibility of using an instrument which is out of
adjustment, we suggest that you have the instrument checked by a competent person before
using it.
Note: Please read the manual thoroughly before starting the following test.
The following test can be performed to check the instrument's accuracy:
Set up the instrument in an area that is as level as possible and which is about 220 feet long. Place
two matching level rods (or drive two pieces of strapping into the ground)about 200 feet apart with
the faces toward each other. Position and level the instrument so that the distance from the
instrument to each rod is the same (measure; Fig. 2).
6 DGTA-5
O n i t s u r m e t n h s a b
11 Carrying Handle
12 Handle Screw
13 Plate Level
14 Tribrach Clamp Knob (DGTA-5 Only)
15 Battery Case
16 Focusing Knob
17 Eyepiece
18 Vertical Clamp Knob
19 Vertical Tangent Screw
20 Circular Level (DGTA-5 Only)
e n e n i p s e t c d e t w c i f e r o c a u c a r y c b e o f e r e l v a n i g h t e