Functional Description; Assembly - Porter Cable TIGERCLAW 750 Manuel D'utilisation

Scie egoine electrique

Masquer les pouces Voir aussi pour TIGERCLAW 750:

Manuel d'utilisation (48 pages)

Table Des Matières

Table des Matières

Les langues disponibles

Some dust created by power sanding, sawing, grinding, drilling, and other

construction activities contains chemicals known to the State of California to cause cancer,

birth defects or other reproductive harm. Some examples of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and other masonry products, and

• arsenic and chromium from chemically-treated lumber (CCA).

Your risk from these exposures varies, depending on how often you do this type of work.

To reduce your exposure to these chemicals: work in a well ventilated area, and work

with approved safety equipment, such as those dust masks that are specially designed

to filter out microscopic particles.

• Avoid prolonged contact with dust from power sanding, sawing, grinding,

drilling, and other construction activities. Wear protective clothing and wash

exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or

lay on the skin may promote absorption of harmful chemicals.

Use of this tool can generate and/or disburse dust, which may cause serious

and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory

protection appropriate for the dust exposure. Direct particles away from face and body.

SYMBOLS

The label on your tool may include the following symbols. The symbols and their

definitions are as follows:

V ....................... volts

Hz .................... hertz

min ................... minutes

................ direct current

.........................

..................... Class I Construction

.........................

(grounded)

.................... Class II Construction

.........................

(double insulated)

.../min .............. per minute

OPM ................ orbits per minute

MOTOR

Be sure your power supply agrees with nameplate marking. 120 Volts AC means your tool

will operate on alternating current. As little as 10% lower voltage can cause loss of power

and can result in overheating. All PORTER-CABLE tools are factory-tested; if this tool does

not operate, check the power supply.

Accessories must be rated for at least the speed recommended on the tool

warning label. Accessories running over rated speed can fly apart and cause injury. Accessory

ratings must always be above tool speed as shown on tool nameplate.

To reduce the risk of injury, turn unit off and disconnect it from power

source before installing and removing accessories, before adjusting or when making

repairs. An accidental start-up can cause injury.

The PORTER-CABLE variable angle reciprocating saw is designed for cutting wood up

to 12" thick, metal up to 3/4" thick and various other materials (plastics, fiberglass and

hard rubber).

NOTE: This tool is shipped completely assembled. No assembly time or tools are

required.

Save theSe inStructionS