Assembly Instructions - Inventum VST401W Mode D'emploi

2

assembly instructions

Before using the fan for the first time, please proceed as follows: carefully unpack the appliance and all components and remove all
packaging material and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of the reach of children. After
unpacking the appliance, check it for external damage that may have occurred during transport.
Assemble the fan in accordance with the instructions.
In order to make the assembly process more easy, we recommend removing components [ a ] and [ b ] before you start.
1. Start by placing the footplate at the pedestal. Align the pedestal with the groove on the footplate and attach them to one another
with the hook bolt [ b ] .
2. Place the motor section on the pedestal and fasten it with screw [ a ].
3. Place the rear protective guard on the fan.
4. Fasten it by tightening the lock ring.
5. Insert the fan blade onto the fan. Test the fan blade by rotating it by hand. During rotation,
the blade should not create any friction with the lock ring. If it does, remove the fan and repeat all steps from the beginning.
6. Mount the fan blade with the fastening cap. Tighten the fastening cap by turning it to the left - counter-clockwise.
7. Place the front protective guard on the fan and use the clamps to attach it to the rear protective guard.
- Align the front protective guard with the rear protective guard using the positioning clamp [ c ] on the
bottom side in order to attach both parts to each other properly. Use the bolt and nut at the top of the guards to fasten the
guards to each other.
- Press the clamps [ d ] downwards in order to fasten the front and rear protective guards to each other.
Motor
a
2
1
b
3
4
Protective guard - rear
Pedestal
b
Footplate
c
Lock ring
5
Fan blade
Fastening cap
6
7
Protective guard - front
bolt and nut
d
d
d
English
d
d
•
11