Installation; How To Use - Omcan DI-CN-0012-C Instructions

Installation

USEFUL INSTRUCTIONS FOR TRANSPORT
1. In order to prevent the oil contained in the hermetic compressor from flowing into the cooling
circuit, it is necessary to always carry, store and handle the machine in a vertical position, following
the instructions found on the packaging.
2. If the machine was accidentally or purposely placed in a non-vertical position during transport,
before operating the machine, it should be kept in a straight position for approximately 30 minutes
to allow the oil to flow back into the compressor.
Unpacking
Remove cardboard and plastic covering. Make sure that the machine has not been damaged. Remove the
plastic film from all the stainless steel panels if there is any.
Important: The various packaging should be kept from children since they are potentially dangerous.
Positioning
Place machine on a horizontal and sturdy surface. For a good ventilation, keep a distance of 20cm (7")
between the unit and the walls or other objects. Increase the distance if the obstacles are a heating source.
When the dispenser is in place, adjust the legs in order to keep it level.
Electrical Connection
Before inserting the plug into the electrical socket, carefully read the following precautions:
• Make sure that the machine is properly connected to a dedicated and efficient grounding system that is in
compliance with the standard safety norms.
• Make sure that the voltage is in accordance with what is indicated on the rating plate.
• The current available is sufficient for the maximum required by the machine.
• If necessary, use only approved multiple outlets in compliance with current safety standards.
• If in doubt, consult only specialized technicians.
BY LAW THE MACHINE MUST ALWAYS BE GROUNDED.
Operation

HOW TO USE

Before use, the dispenser should be cleaned carefully as it comes into contact with drinks.
Refilling
For a correct usage of the machine, ensure that the liquid level into the bowl does not go below 3-4 Liters.
• Before filling up the container make sure to remove the power plug.
• Mix product in a separate container.
• Do not fill the container with hot product.
• Do not exceed the MAX level line.
6