Inserting Batteries; Battery Precautions - JVC AV-20FD23 Mode D'emploi

Remote control

Inserting Batteries

1
Slide the battery compartment
cover in the direction of the
arrow.

BATTERY PRECAUTIONS

The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the "–" end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer's directions.)
6. When you change the batteries, try to complete the task within three minutes. If you take longer than three
minutes, the remote control codes for your Cable Box may have to be reset (see page 50).
REMOTE CONTROL BASICS
• Before you can operate the remote control, you must first install the batteries (included). See
"Inserting Batteries" on this page above for instructions.
• Press the POWER button to turn the television on or off.
• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if you need to operate a cable box.
(You must set the remote control to operate a cable box. Please see page 50 for instructions.)
• Press the CH + and CH – buttons to scan through the channels. Tap the CH + or CH – button to move through
the channels one channel at a time.
• Press VOL + or VOL – to raise or lower the volume. An indicator bar will appear onscreen to show you the
television volume level.
• The CH +/– and VOL +/– buttons are also used to navigate JVC's onscreen menu system.
• You can directly access specific channels using the 10-key pad.
• This remote includes illuminated buttons for key features like CH +/– buttons, and VOL +/– buttons. Press the
LIGHT button to turn the illumination on.
• Each press of TV/DVD on the remote control, switches the screen between the TV screen (TV mode) and the
DVD screen (DVD mode). You can operate a TV and TV menu in the TV mode, and a DVD and DVD SETUP
menu in the DVD mode.
Operation
• Aim the remote control at the remote sensor and
press control buttons to operate.
• Operate the remote control within 30° angle on
either side of the remote sensor, up to a dis-
tance of Approx. 5 meters.
10
2
Install two "AA" batteries
(supplied), paying attention to
the polarity diagram in the
battery compartment.
3
Replace the compartment
cover.
Approx. 5 meters