Magnum Flying Santa Manuel D'instructions page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

TRIMMING THE CONTROLS
• Gently push the throttle up to raise the Flying Santa about 1.5 to 2 meter from the ground.
• If your Flying Santa veers right (fig. 2),press the left side
trimmer continually until it stabilises (fig. 3).
Keep going right
fig. 2
• If your Flying Santa pitches forward (fig. 6), press the backward
trimmer continually until it stabilises (fig. 7).
Keep going forward
fig. 6
FLYING THE DRONE
LIFT-OFF PROCEDURE (after pairing procedure is completed):
• Put the Flying Santa on flat ground – an uneven surface will adversely affect it takes off.
• Slowly increase the throttle.
• DO NOT look at the remote control transmitter but focus on the Flying Santa.
• As soon as the Flying Santa leaves ground, reduce the throttle slightly. (in the worst case, the Flying Santa will return to the floor, but this is
better than crashing against the ceiling)
• VERY gently increase the throttle if the Flying Santa goes down.
• VERY gently reduce the throttle if the Flying Santa goes up.
• When turning, give brief, small inputs to the direction stick. (most beginners will commonly overcontrol the Flying Santa)
• If your Flying Santa veers left (fig. 4), press the right side
trimmer continually until it stabilises (fig. 5).
Keep going left
fig. 3
• If your Flying Santa pitches backward (fig. 8), press the forward
trimmer continually until it stabilises (fig. 9).
Keep going backward
fig. 7
5
fig. 4
fig. 8
fig. 5
fig. 9

Publicité

Table des Matières
loading

Produits Connexes pour Magnum Flying Santa

Table des Matières