Waring Commercial CTS1000 Mode D'emploi page 7

OPERATION INSTRUCTIONS
Initial Preparation
• Place Waring
countertop with a minimum of a 2" clearance between
the side and back walls.
NOTE: If unit is not seated properly, the feet are
adjustable for balancing.
• Remove all parts (reflector/crumb tray and toast drawer)
and clean thoroughly before first use.
• Replace all parts and plug unit into appropriate outlet
(see previous page).
• Switch unit to the On position. The red Power On
indicator light will illuminate.
IMPORTANT: Make sure the standby switch is in the
Full power position (to the left).
• When conveyor toaster is ready for toasting, the green
Ready indicator light will illuminate. This should take
approximately 5 minutes.
• Turn the conveyor speed control knob to set the desired
toasting speed.
• When the main power switch is turned to the OFF
position, the cooling fan and green ready indicator light
may stay on up to 5 minutes for cooling.
Toasting
• Place bread, bagel or muffin to be toasted on wire
bread feeder. The conveyor toaster will automatically pull
bread into the toasting chamber at the speed set by the
conveyor speed control knob.
• When complete, toast will slide down bread chute into the
toast drawer.
Commercial Conveyor Toaster on level
™
6