Setup Instructions - hawa 1201 Instructions De Montage

4. Setup Instructions

Please check the product for completeness and damages.
Suitable measure must be taken during mounting of the cable duct parts to secure the product against tipping over - attention must be
paid to load distribution and center of gravity.
Independently of the attachment type (e.g. channel brackets, angle brackets, profiles, supports, etc.) of cable ducts type 1201 to walls,
ceilings, etc. or connection to machines and control cabinets, the maximum distance between two attachment points must not exceed
1500 mm (5 ft).
See item 7 "Technical Data" for the maximum load.
Pay attention to a clean working environment to avoid slipping and/or falling.
Use appropriate protective equipment (e.g. gloves, safety shoes).
Please observe the instructions specified under "Mounting" when setting up the system and carry out a visual inspection after assembly.
Please check if:
• a continuous protective conductor function is provided
• all joints are equipped with a rubber flange
5. Mounting
5.1
Mounting instructions for a correct assembly of the cable duct system type 1201.
When using other fittings, the joints must be performed in the same manner.
Item Description
Pos. Bezeichnung Pos. Bezeichnung
1 Straight cable duct
1 1 Leitungkanal gerade Leitungkanal gerade
3 90° elbow
3 3 Winkelstück 90° Winkelstück 90°
5 5 T-Stück T-Stück
5 T-section
11 11 Endplatte Endplatte
11 End plate
12 12 Flanschgummi für Serie 1201 Flanschgummi für Serie 1201
13 13 Verbindungsschrauben Verbindungsschrauben
12 Rubber flange for series 1201
Kabel für Kabel für
15 15
13 Connecting screws
Schutzleiteranschluß Schutzleiteranschluß
15 Cable for protective ground Cable for protective ground
connection connection
10
endplatte-gr.100-gesamtaufbau-anleitung.SLDDRW
K-1201-anleitung-gesamtaufbau-II-de.pdf
1
8 Nm
8 Nm
5
12
13
15
1
12
12
3
12
1
Maße in mm
Gewicht: $weight
Laserbearbeitung DIN EN ISO 9013-1
DIN ISO
Stanzen DIN 6930-2-m
5456-2
Biegen NF E 02-352-n
Allgemeintoleranz Schweißen EN ISO 13920-B
DIN ISO 2768-1-m Schweißvorgabe WPS DIN EN ISO 5817 - D
Datum Name E
erst. $created_at $created_by E
bearb.$changed_at $changed_by U
gepr. $rel_at $rel_by
gen. $norm_at $norm_by