Porter Cable 503 Manuel D'utilisation page 5

19. Stay Alert. Watch what you are doing. Use common sense. Do not
operate tool when you are tired.
20. Check Damaged Parts. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to determine that it will
operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any
other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced by an authorized service
center unless otherwise indicated elsewhere in this instruction manual. Have
defective switches replaced by authorized service center. Do not use tool if
switch does not turn it on and off.
ADDITIONAL SPECIFIC SAFETY RULES AND SYMBOLS
1. Hold tool by insulated gripping surfaces when performing an
operation where the cutting tools may contact hidden wiring or its own
cord. Contact with a "live" wire will make exposed metal parts of the tool
"live" and shock the operator.
2. Use proper safety equipment. Wear safety goggles to protect your
eyes, wear hearing protection to protect your ears, and wear a
protective mask to minimize breathing in the fine dust created while
sanding.
3. Sanding of lead-based paint is not recommended. Lead-based paint
should only be removed by a professional.
4. Always maintain a firm grip on the belt sander handles with both
hands to prevent loss of control.
5. Do not operate belt sander without all guards and covers securely
in place.
6. Some wood contains preservatives which can be toxic. Take extra
care to prevent inhalation and skin contact when working with these
materials. Request, and follow, any safety information available from your
material supplier.
7.
designed. Porter-Cable strongly recommends that this tool NOT be
modified and/or used for any application other than for which it was
designed. If you have any questions relative to its application DO NOT use
the tool until you have written Porter-Cable and we have advised you.
SYMBOL
V ........................ volts
A ........................ amperes
Hz ........................ hertz
W ........................ watts
kW ........................ kilowatts
µF ........................ microfarads
l ........................ liters
kg ........................ kilograms
N/cm 2 ........................ newtons per square centimeter
Pa ........................ pascals
h ........................ hours
min ........................ minutes
SAVE THESE INSTRUCTIONS
There are certain applications for which this tool was
DEFINITION
5