DIRECTIONS FOR USE
8. Add Essential Oil: slide aroma tray out from back of the salt
tray. Add a few drops of your favorite essential oil to the pad
in the tray (oil not included). WARNING: DO NOT add oils
or other additives directly into the water tank. DO NOT add
oils directly to the salt crystals. Add only to the pad in the tray.
10. Plug cord into back of humidifier and then plug unit into the wall outlet.
NOTE: The salt lamp can be operated with or without the humidifier.
OPERATING INSTRUCTIONS
Timer
Power
Press the timer
Press the power
button to select
button to turn the
2, 4 or 8 hours.
humidifier on and
The humidifier will turn
again to turn off.
off after that time.
Any lights on the salt
lamp will need to be
turned off manually.
Water Refill Indicator
When the unit is low on water the Power LED will turn from white to flashing white.
E-6
9. Return the salt tray to the
humidifier so that it fits
firmly in the unit. If it
doesn't fit rearrange the
crystals for a better fit.
Light
Mist
Select preferred
Select low or high
light level.
mist by pressing
the control button
Press once for upper
once for high and
lamp only.
twice for low.
Press twice for both upper
Default speed:
and salt crystal lamp.
I speed (Low)
Press three times for the
1st press:
salt crystal lamp only.
II speed (High)
Press four times to
2nd press:
turn off lights.
I speed (Low)
CLEANING
Always unplug the unit before servicing in any way.
GENERAL CLEANING
1. Remove salt tray and dust off the salt crystals with a clean dry cloth. Do not wash or clean
salt crystals with water or liquid detergents. If the salt crystal becomes moist, gently pat down the
crystal surface with a dry cleaning cloth.
2. Empty water tank. Remove mist spout and clean with fresh water and a light brush (bottle cleaning
brush is recommended).
3. Wipe outer surface of the unit with a soft, damp cloth if needed. If you notice an accumulation
of water during usage, reduce humidity and dry outer surface with a cloth.
DESCALING
• Depending on usage and water type, cleaning to remove scale may be required
weekly or every other week to optimize unit performance.
• If you live in a hard water area, we recommend the use of distilled water for your
humidifier. This will help reduce the precipitation of minerals or 'white dust'.
• Do not clean the unit or water tank with detergents or cleaning chemicals of any kind.
ULTRASONIC DISK
1. Unplug unit.
2. Remove the tank and empty all water from unit base and tank.
3. Locate the ultrasonic disk on the inside center of the base unit.
4. Use ONLY the enclosed cleaning brush to gently clean disk
and remove build up and deposits. Do not scrub or scrape
the ultrasonic disk.
If scale becomes difficult to remove with brush:
1. Fill the Base with: mixture of 1 tsp. white vinegar and 1 tsp. water.
2. Let solution stand for 5 minutes.
3. With the vinegar in the Base, clean all interior surfaces with a soft
cloth or brush to help remove scale.
4. Also check mist nozzle and mist tube in water tank. Clean as needed.
5. Rinse the Base thoroughly with water to remove scale and vinegar solution.
END OF SEASON STORAGE
1. Follow the Cleaning and Descaling instructions when the humidifier will be stored at the end
of the season.
2. Carefully remove the salt crystals and store in a sealed bag or container.
3. Dry the humidifier completely before storing. DO NOT store with water inside the base or water tank.
4. Pack the unit and in its original carton and store in a cool, dry location.
IMPORTANT: IF YOU EXPERIENCE A PROBLEM DO NOT ATTEMPT TO OPEN THE MOTOR
HOUSING YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO
THE HUMIDIFIER OR PERSONAL INJURY.
Ultrasonic
Disk
E-7