ShelterLogic 70615 Instructions D'assemblage page 8

7. AncHoR THe FRAme
A. Use the provided steel driving rod and a sledge hammer to drive each EasyHook™ anchor into the ground.
Leave approximately 8 inches of cable exposed above the surface.
B. Remove the driving rod and insert it through the loop of the cable. Pull up on the cable to set the anchor.
C. Wrap the cable around each corner leg above the cover rail and clamp closed.
A B
To avoid serious damage or injury,
noTe:
frame MUST be properly anchored!
Page 8
c
05_70615_0B