How To Use - SYNQ Digit 1K0 Mode D'emploi

ENGLISH
13. 30Hz LOW CUT FILTER: eliminates unwanted subsonic frequencies under 30Hz. In most cases these
frequencies only consume a lot of energy without any added value to the music.
14. OPERATION MODE switch: Used to set the operation mode of the amplifier. The most common
operation mode is "stereo". If you need more power, you can operate the amplifier in bridge mode. In
mono mode you only have to connect the left input to drive both outputs. Refer also to n° 3 for more
information.
15. INPUT SENSITIVITY SWITCH: you can choose 3 different input levels: 26 dB / 32 dB / 1,4 V
16. BALANCED XLR OUTPUTS: Can be used to send the signal to the next amplifier. Pin1: signal ground,
Pin2: signal+, Pin3: signal -
17. BALANCED XLR INPUTS: Pin1: signal ground, Pin2: signal+, Pin3: signal –

HOW TO USE

STEREO OPERATION:
• Connect the audio signal to the inputs (15 or 16)
• Set the operation mode switch (13) to "stereo"
• Connect the matching speakers to the L+R Speakon
• Make sure the mains voltage matches 230Vac before connecting the
mains cable to the earthed wall socket.
• Set both input gains (2) to zero
• Make sure there's a music signal at the input
• Turn the amplifier on (8)
• Adjust the input gains (2) to the desired level
BRIDGE OPERATION:
• Connect the audio signal to the left input (15 or 16)
• Set the operation mode switch (13) to "bridge"
• Connect the matching speaker(s) to the Bridge output (12)
• Make sure the mains voltage matches 230Vac before connecting the
mains cable to the earthed wall socket
• Set both input gains (2) to zero
• Make sure there's a music signal at the left input
• Turn the amplifier on (8)
• Adjust the left input gain (2) to the desired level, leave the right channel
gain to zero.
MONO OPERATION:
• Connect the audio signal to the input of the left channel (15 or 16)
• Set the operation mode switch (13) to "mono"
• Connect the matching speakers to the L+R Speakon
• Make sure the mains voltage matches 230Vac before connecting the
mains cable to the earthed wall socket
• Set both input gains (2) to zero
• Make sure there's a music signal at the input
• Turn the amplifier on (8)
• Adjust the left input gain (2) to the desired level, leave the right channel
gain to zero.
SYNQ
®
®
outputs (11)
®
outputs (11)
5/36
OPERATION MANUAL
DIGIT amplifiers