Installation/Setup - Renkforce 1267774 Notice D'emploi

9. Installation/Setup

Before firmly installing the outdoor sensor, ensure that the weather station
receives the radio signal of the outdoor sensor without problems.
• The outdoor sensor can be attached to the wall on a nail, screw or hook using an
opening on the rear.
The outdoor sensor is suitable to be used in a protected outdoor area. It should be
placed so that it is not subject to direct solar irradiation, because the measured values
will be incorrect otherwise. Precipitation on the outdoor sensor also leads to incorrect
temperature measurement because the casing cools off. Never immerse or submerge
the outdoor sensor in water; it would be destroyed!
We therefore recommend careful selection of the site of set-up for the outdoor sensor
to measure the correct temperature (and humidity).
• The weather station can be put up on a level, stable surface with the base integrated
firmly into the housing. Protect valuable furniture surfaces from scratches with suitable
pads.
Selet a location as operating site that is not in the sun or next to a radiator. This will
falsify the temperature or humidity display.
37