Sams SND-7080F Guide De Prise En Main Rapide page 9

IP setuP
Manual network setup
Run <IP Installer_vX.XX.exe> to display the camera search list.
At the initial startup, both [auto set] and [Manual set] will be grayed out.
For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not
M
support this function.
1.
Select a camera in the search list.
Find the MAC (Ethernet) address
labeled on the rear of the camera.
Both the [auto set] and [Manual set]
buttons will be activated.
2. Click [Manual set].
The Manual Setting dialog appears.
The default values of <IP address>,
<subnet Mask>, <Gateway>, <httP Port> and <vnP Port> of the camera will
be displayed.
3.
In the <address> pane, provide the
necessary information.
MAC (Ethernet) Address : The MAC

(Ethernet) address of the applicable
camera will be set automatically so
you don't need to input it manually.
You can configure the static IP settings
M
only if the DHCP checkbox is unchecked.
4.
In the <Port> pane, provide necessary information.
HTTP Port : Used to access the camera using the Internet browser, defaulted to

80. Use the spin button to change the HTTP Port value.
VNP Port : Used to control the video signal transfer, defaulted to 4520.

5.
Enter the password.
This is the login password for the "admin" user who accesses the camera.
The default password is "4321".
6.
Click [oK].
Manual network setup will be completed.
English _