Functional Description; Installing / Removing Battery Pack - Black & Decker LSW221 Mode D'emploi

FUNCTIONAL DESCRIPTION

1. On / Off Switch
2. Tube
3. POWERBOOST™ Button (LSW321 Only)
LSW221
LSW321
This product can accept any of the batteries and
chargers listed in the chart below.
LI-ION Battery Packs and Chargers
Description
Batteries: LI-ION
Chargers:
TUBE ASSEMBLY
NOTE: Ensure the sweeper is switched off
and the battery is removed before attaching or
removing the sweeper tube. The tube must be
assembled to the housing before use.
• To attach the tube to the sweeper, line
up the tube with the sweeper housing as
shown in figure A.
• Push the tube into the sweeper housing
until the lock button (4) engages the lock
hole (5) in the tube.
A
2
2
4
5
Cat. #
LBX20
LBXR20
LBXR2020
LCS200
LCS1620
INSTALLING / REMOVING
BATTERY PACK
• TO INSTALL BATTERY PACK:
Insert battery pack into tool until an
audible click is heard as shown in figure
B. Make sure battery pack is fully seated
and fully latched into position.
• TO REMOVE BATTERY PACK:
Depress the battery release button (6)
in the back of the battery pack and
pull battery pack out of tool assembly as
shown in figure C.
B
6
1
3
1