Ardisam Eskimo Ice Fishing Gear HC40Q8 Manuel De L'utilisateur page 7

General Maintenance
Please refer to the maintenance table for all auger and
engine service. It is important that you read this manual
entirely. Following these recommendations will help you
enjoy your propane auger for many years. The following
routine inspections and maintenance guidelines are
relatively simple to conduct, and require few tools. If any
doubt exists on how to properly do the recommended
maintenance, please call customer service or take to an
authorized service center.
Maintenance, replacement, or repair of the emissions
control devices and systems may be performed by any
non-road engine repair establishment or individuals.
However, all authorized warranty repairs must be
handled by an authorized service center.
The maintenance schedule applies to normal operating
conditions. If you operate your engine under unusual
conditions, such as sustained high-load or high-temperature
operation, or use in unusually wet or dusty conditions,
consult your servicing dealer for recommendations
applicable to your individual needs and use.
WARNING
• WHEN SERVICING OR INSPECTING ANY
COMPONENT OF THE AUGER OR ENGINE,
ALWAYS DISCONNECT THE SPARKPLUG
WIRE FROM THE SPARKPLUG, AND SET OFF
TO THE SIDE WHERE IT CANNOT ARC TO
THE SPARKPLUG LEAD.
CAUTION
TO PREVENT ACCIDENTAL STARTING:
• AVOID INJURY! ENGINE MUST BE TURNED
OFF AND COOL, AND SPARK PLUG WIRE MUST BE
REMOVED FROM SPARK PLUG BEFORE CHECKING
AND ADJUSTING ENGINE OR EQUIPMENT.
• AVOID INJURY! TEMPERATURE OF MUFFLER AND
NEARBY AREAS MAY EXCEED 150º F
(65º C). AVOID THESE AREAS.
• AVOID INJURY! CHECK AUGER OFTEN FOR LOOSE
NUTS AND BOLTS. KEEP THESE ITEMS TIGHTENED.
• AVOID INJURY! AN ADULT MUST ALWAYS DO
MAINTENANCE AND REPAIR ON ENGINE AND
AUGER.
• AVOID INJURY! ENGINE MUST BE SHUT-OFF,
COOL, AND SPARK PLUG WIRE REMOVED BEFORE
ANY REPAIR OR MAINTENANCE CAN BE DONE.
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
NOTE: All repair parts must come from the factory. Never
replace parts that are not specifically designed for
the engine or auger.
NOTE: The ends of the bolt should be flush with auger collar.
Bolt head and thread end should never go beyond
auger collar.
Fasteners
Always check the nuts, bolts, screws, and general condition of
the engine and auger.
Blades
Check blades for nicks or shiny areas along the cutting edge,
if these signs are present, it is time to replace the blades.
Check ice point for nicks and dull edges.
Ice Point Replacement (SEE FIGURE 1)
1. Remove blade protector and both blades.
2. Remove nut and retaining bolt from point.
3. Using a locking pliers, grasp point and pull out. If holder
doesn't come out with the point, remove with pliers.
4. With locking pliers, push in new point and holder
aligning bolt hole in point with holes in auger shaft.
DO NOT damage end of point.
NOTE: When installing holder in auger shaft, edges
of holder may shave off.
5. Insert retaining bolt and tighten with nut.
6. Re-attach both blades and put blade protector back on.
AUGER
SHAFT
NUT
POINT
Operator's Manual
Propane Powered Ice Auger
FIGURE 1
BOLT
HOLDER
BOLT
HOLE
LOCATING
HOLE
7