G5V001; Assembling; Operating; Oscillation - G3 Ferrari EOLOS 30 Manuel D'instructions

DESCRIPTION G5V001
1 Front protection grid
4 Rear fan stopper
6 Drive shaft
9 Inclination pin
11 Detachable base
13 Power cord
15 Motor protection

ASSEMBLING

The fan motor can work even if the protective grids have not yet been assembled and fixed. To ensure the
maximum safety, perform the installation completely before operating.
1) Insert the base (14) in the detachable base (11), as shown in the figure.
2) Joint the appropriate clips and stop the two sides with the supplied screws (12).
3) Place the rear grid (5) near the plastic motor protection (15) with the metal handle
facing upwards. Fit the holes present in the central part of the grid with the pins in
the plastic protection (15) and lock the two parts with the stopper (4).
4) Insert the fan (3) into the shaft (6) and screw the cover of the fan (2) to the
threaded end of the drive shaft. Loosen the screw in the ring (16). Do not fully
unscrew the screw.
5) Place the retaining ring (16) around the rear grid (5) with the screw located at the bottom.
6) Place the front grid (1) in front of the rear grid (5) matching the grooves on the ring (16) with the outer
wires of the grids. Tighten the screw fixing ring (16) to secure both the grids.
The fan installation is now complete.

OPERATING

Once finished assembling the unit, place the fan following the safety instructions, then plug it to the electrical
outlet. By using control panel (10) the rotation power can be adjusted on different speeds.
- 0: fan is OFF
- 1: low speed
- 2: medium speed
- 3: high speed

OSCILLATION

The oscillation of the head is only possible when the fan is turned on and it can be activated by pressing the
pin (7) downwards until it locks. Lifting the pin (7) until the locking function is disabled. It is recommended
to enable or disable oscillation of the fan only when the unit is off.

VERTICAL ADJUSTMENT

To ensure a always good ventilation, the fan can be adjusted vertically.
Turn off the fan and wait for the blades to stop.
- Loosen the pin (9) and tilt the head of the fan to the desired position.
- Tighten the pin (9) by holding the fan in that position.

CLEANING

Disconnect the plug from the electrical outlet before attempting any cleaning operation.
Do not immerse the unit in water. In any case prevent splashes of water or other liquids reaching the motor
body. Do not clean the unit with metallic sponges or abrasive cleaners, only use neutral detergents and a soft
cloth moistened with water to clean the outer parts.
Dry the product completely before operating the unit.
2 Fan stopper
5 Rear protection grid
7 Oscillation pin
10 Control panel
12 Screws for the base
14 Base
16 Front grid fixing ring
3 Fan
8 Main body
10