Duct Condition Testing - LG DLE2301W Guide De L'utilisateur

DUCT CONDITION TESTING

Your dryer features FlowSense
sensor system that automatically detects
blockages and restrictions in dryer ductwork.
Keeping ductwork clean of lint build-up and free
of restrictions allows clothes to dry faster and
reduces energy use.
NOTE: When the dryer is fi rst installed, this test
should be performed to alert you to any existing
problems with the exhaust duct in your home.
However, since the test performed during normal
operation provides more accurate information on
the condition of the exhaust duct than does the
installation test, the number of bars displayed
during the two tests may not be the same.
To activate the duct condition test cycle:
NOTE: Dryer heating test must be performed
before proceeding. (Gas dryer only)
Then perform the duct condition test below.
Press and hold the DAMP DRY BEEP and
1
TEMP CONTROL buttons at the same time.
While holding these buttons, press POWER
ON/OFF.
The dryer will show lnS in the number display
2
to indicate that it is in duct condition testing
mode.
Press START/PAUSE. The dryer will run for
3
approximately 2 minutes to test
for blockages or restrictions to air
fl ow in the ductwork.
If no bars are shown in the display,
the ductwork is free from blockages
or restrictions.
If all bars are lit, the dryer ductwork
has a blockage that needs to be
removed immediately.
IMPORTANT: Do NOT interrrupt the test cycle!
24
, an innovative
™
Correct Venting
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows
or bends.
Check for blockages and lint buildup.
Make sure the ductwork is not crushed
or restricted.