Power Plug; Location; Operating Environment; Crusher Components - Intimus 360 Destroyer Instructions D'opération

GB
3 . Slide the red power setting switch to either the
115V or 230V setting. Choose the setting that most
closely matches your power mains voltage (Fig. 3).
Fig. 3 Red power setting switch

5 .2 Power Plug

Plug the IEC connector attached to the power cord
supplied into the receptacle on the back of the unit.

5 .3 Location

The intimus 360 Destroyer/360 Crusher must be placed
on a flat, hard and secure horizontal surface. Position
the intimus 360 Destroyer/360 Crusher to allow proper
air flow from the side air inlets and the rear exhaust. A
minimum clearance of 6 inches from any obstructing
wall or solid surface is recommended.

5 .4 Operating Environment

Do not use or keep the intimus 360 Destroyer/360
Crusher in environments with excessive heat, cold, hu-
midity, or dust.
Use caution when bringing the intimus 360 Destroy-
er/360 Crusher from a cold environment into a warm
environment. If moisture has accumulated due to a
sudden change of temperature, wait 1 hour until mois-
ture has completely dissipated before operating the
machine.
94926 01 05/18
6

Crusher Components

6 .1 Front Panel Identification

1
2
000169
3
4
1 Power Button
2
LCD Display
3
Destroy Button
4
Door Handle
Fig. 4 Front panel
1 = Power Button
Applies power to the intimus 360 Destroyer/360 Crus-
her.
2 = LCD Display
32 Character LCD Display with counter for Session and
Total.
3 = Destroy Button
Initiates the destruction function.
4 = Door/Door Handle
Prevents access to the HDD and destruction wedge
during the destruction process. If opened during the
destruction process, the destruction wedge will auto-
matically stop. When the door is closed, the destruc-
tion wedge will return to its home position.
360 Destroyer / 360 Crusher
000157
13