Technical Data; Disposal Of Old Electrical Appliances - Beper RI501SL Manuel D'instructions

Electric fireplace Use instructions
Press the ON/OFF button once to turn on the appliance and fire effect.
Press the 900W/1800W button once for the low heat setting 900W; press twice for the high heat
setting 1800W; press three to switch off the heat setting. Press the LED COLORS button to adjust
the colors of LED decoration, 7 colors available. Press the DIMMER' button to operate the dimmer
mode, repeat pressing will raise and lower the brightness.
SAFETY CUT-OFF
• This appliance is fitted with a safety cut­off which will operate if the fire overheats (ex. Due to blo­
cked air vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect the supply to the mains and switch on the appliance.
TROUBLESHOOTING
Symptom
No operation/ no fan
No fire effect light
Cleaning and Maintenance
Warning­ Always disconnect from the mains supply before cleaning heater.
For general cleaning use a soft clean duster ­ never use harsh abrasive or cleaners.
The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use proprietary
glass cleaners. This product does not use a standard bulb for its flame effect. The appliance uses
an electronically controlled LED system to create the effect, therefor no parts need to be replaced.
There are no user­serviceable parts on this appliance. Under no circumstances should the applian­
ce be serviced be anyone other than a qualified electrician.

TECHNICAL DATA

Power supply: 220V­240V~ 50Hz
Power: 1800W
Illumination: LED system

DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), re­
quires that old household electrical appliances must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be collected separately in order to optimize the reco­
very and recycling of the materials they contain, and reduce the impact on human health and the
environment.
The crossed out "wheeled bin" symbol
that when you dispose of the appliance, it must be separately collected.
Solution
Check fuse by replacement.
Check for safety cut­off operation
Check the LED system by qualified electrician
For any improvement reasons, Beper re-
serves the right to modify or improve the
product without any notice.
on the product reminds you of your obligation,