Beper RI501SL Manuel D'instructions page 12

Electric fireplace Use instructions Electric fireplace Use instructions
INSTALLATION
Do not connect the appliance until properly fixed to the wall and the instructions is read fully.
• The minimum safety distances must be observed.
• For installation of the appliance, care must be taken not to damage concealed cables.
• Please be careful while drilling the holes.
• A height of 600 mm from bottom of heater to floor is recommended for optimum viewing of fuel bed
(see Fig. 1 for recommend fixing dimensions).
• For optimum viewing, mark the top four screws fixing positions on wall in accordance with the
recommend fixing dimensions – see Fig.2.
Note: ensure that the bracket is level by using a Spirit level whilst marking out the hole positions.
Drill holes with a screw driver.
• Fix the wall bracket using that the plug and screws provided.
Attach the lower fixing bracket the base of the fire using the 2 small black screws supplied; ensure
the bracket is fitted so that it is level with the back.
• Carefully lift the heater up ensuring that the top rear ledge of heater engages the wall bracket (see
Fig.2 in circle) and is sitting centrally. This process should be carried out by two people to avoid
injury or damage to property or the appliance.
• Gently bring the heater down against the wall.
• Mark the lower fixing bracket to fixing all position on the wall ­ see Fig.3, remove the heater.
• Drill the wall and insert the wall plug.
• Refit the heater to the wall and fasten the bottom fixing bracket to the wall using the screws provi­
ded to permanently fix the heater in place.
• Unpack the pebbles from the bag and place them along the light unit in the desired position.
• Place the front glass surround over the front of the fire aligning the slots in the brackets at each
side of the glass panel with the lugs on the sides of the fire­see Fig.4.
Again two people will be required for this operation.
INSTRUCTIONS FOR USE
• The appliance can be operated either by the switches located on the top right hand side of the fire
or by supplied remote control.
Manual operation
This is done by operating the switches located at the top right hand side of the fire .The standby
rocker switch must first be switched on, the fire will beep to indicate that it is powered up.
Press the O/I button once to turn on the appliance and fire effect. A red indicator light will show to
indicate that the fire is ON. Press the O/I button for 3 seconds this will operate the dimmer mode,
hold the button down until the desired brightness is obtained.
Press the POWER button once for the low heat setting 900W; press twice for the high heat setting
1800W; press three to switch off the heat setting.
Press the LED COLORS button to adjust the colors of LED decoration, 7 colors available.
Remote operation
The standby rocker switch located at the top right hand side of the fire must first be switched on;
the fire will beep to indicate that it is powered up. It takes a little time for the receiver to respond to
the transmitter. Do not press the buttons more than once within two seconds for the fire to operate
normally.
12