MV Agusta F3 Oro Serie Mode D'emploi page 105

High beam flasher button
It is used to attract the attention of other road users in case of danger. When the high beam is on, the function
is inactive.
SET/OK button
The SET button enables to select the display digits to carry out adjustments, while the OK button enables to
confirm the set digits.
3
Low/high beam button
Under normal conditions, the low beam is on. The high beam can be switched on by pressing the button when
allowed by the traffic and road conditions.
Horn button
It is used to attract the attention of other road users in case of danger.
Turn indicator switch
It is used to show the rider's intention to change direction or lane.
WARNING
Failure to switch the turn indicators on or off at the right time may cause an accident in that the
other road users may draw incorrect conclusions about the direction of motion of the vehicle.
Always switch on the indicators before turning or changing lanes. Then be sure to switch off the
indicators after completing the operation.
Clutch lever
It engages/disengages the clutch through a hydraulically controlled device.
CONTROLS AND INSTRUMENTS
- 16 -
3