Installation Instruction - FAR LVC515DS Manuel D'utilisation

ENGLISH

INSTALLATION INSTRUCTION

ATTENTION! The installation of the pipes and electrical equipments
should be done by professionals.
WARNING
Electrical Shock Hazard. Disconnect electrical power before installing
dishwasher. Failure to do so can result in death or electrical shock.
Installation preparation
The installation position of dishwasher should be near the existing water inlet tap and
drain outlet and power socket.
One side of the cabinet sink should be chosen to facilitate the connection of drain
hoses of the dishwasher.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the
wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is
equipped with water supply and drain hoses that can be positioned to the right or the
left to facilitate proper installation.
About Power Connection
WARNING!
For personal safety:
• Do not use an extension cord or an adapter plug with this appliance.
• Do not, under any circumstances, cut or remove the earthing connection
from the power cord.
Electrical Requirements
Please look at the rating label to know the rating voltage and connect the dishwasher
to the appropriate power supply. Use the required fuse 10 amp, time delay fuse or
circuit breaker recommended and provide separate circuit serving only this appliance.
GB-32
Electrical Connection
Ensure the voltage and frequency of the power being corresponds to those on the
rating plate. Only insert the plug into an electrical socket which is earthed properly.
If the electrical socket to which the appliance must be connected is not appropriate
for the plug , replace the socket, rather than using a adaptors or the like as they could
cause overheating and burns.
Insure proper ground exists before use
Water Connection
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(inch)
connector and make sure that it is fastened tightly in
place. If the water pipes are new or have not been used
for an extended period of time, let the water run to make
sure that the water is clear and free of impurities. If this
precaution is not taken, there is a risk that the water inlet
can get blocked and damage the appliance.
Please Note: If the supplied hose does not fit your tap,
please contact your local plumbing supply center where
adapters are available for purchase.
WARNING!
please close the hydrant after using.
ENGLISH
GB-33