Assembly Of Utensilwasher - Mondial Framec DOLCE VITA Mode D'emploi Original

10 - ASSEMBLY OF UTENSILWASHER (OPTIONAL)
1. Screw the utensilwasher
utensilwasher (B) using the screws (C) on the rear of
the cabinet.
With water recirculation:
2. Secure the water load fitting (3) with in-built valve,
positioned as shown in the figure, to the container (2)
via the mounting nut (4).
3. Connect the "overflow" tube in stainless steel (7) to the
bush (6) and fix them to the container with the nut (5).
4. Connect the water load fitting (3) with the rubber hose
to a tap and fill the container (2) with clean water;
5. Connect a rubber hose to the bush (6) and drain the
excess or dirty water (filtered from the cover/partition
(8) to a washbasin.
Without water recirculation:
1. Secure the water load fitting (3) with in-built valve,
positioned as shown in the figure, to the container (2)
via the mounting nut (4).
2. Connect the "overflow" tube in stainless steel (7) to the
bush (6) and fix them to the container with the nut (5).
3. Connect a rubber hose to the bush (6) and drain the
excess or dirty water (filtered from the cover/partition
(8) to a washbasin.
4. Manually fill the container with clean water.
support (A) to the
Page 17 | 47