F Reezer S Ection; P Reparing To M Ove - Dacor EF36BNF Manuel D'utilisation Et D'entretien

c
are and
f S
reezer ectIon
1. Reach behind the light cover.
2. With firm pressure, press
forward on the notches at the
back of the cover and pull
down. The cover will open
from the back.
3. Remove the cover.
4. Remove light bulb.
5. Replace bulb with appliance
bulb no greater than 40
watts.
6. Insert front tabs of light cover
into slots in freezer liner
and snap rear portion over
light assembly until rear tab
engages.
p
reparIng for
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for
cleaning or service, be sure to protect the floor. Always pull the
refrigerator straight out when moving it. Do not wiggle or "walk"
the refrigerator when trying to move it, as floor damage could
occur.
For short vacations or absences (three months or less):
1. Remove all perishables.
2. If no one will be checking in on the refrigerator during your
absence, remove all frozen items also.
3. If your refrigerator has an automatic ice maker:
• Shut off the water supply to the ice maker at least one
day ahead of time.
• After the last load of ice drops, raise the wire shut off
arm to the OFF position.
• Empty the ice bin.
4. If the room temperature will drop below 55°F (13°C), follow
the instructions for longer absences.
For long vacations, absences (more than three months) OR if
the room temperature will drop below 55ºF (13°C):
1. Remove food.
2. If your refrigerator has an automatic ice maker:
• Shut off the water supply to the ice maker at least one
day ahead of time.
• After the last load of ice drops, raise the wire shut off
arm to the OFF position.
• Empty the ice bin.
c
leanIng
v /a
acatIon bSence
3. If your refrigerator has a dispenser system with water filter,
remove the water filter cartridge and install the filter bypass.
Dispose of the used cartridge.
4. Turn the freezer control to OFF.
5. Unplug the refrigerator.
6. Thoroughly clean the interior of both compartments with a
baking soda solution and a clean soft cloth (four tablespoons
of baking soda in one quart of warm water).
7. Dry thoroughly.
8. Leave the doors open to prevent the formation of mold and
mildew.
u y r
pon our eturn
After a short vacation or absence:
For models with automatic ice makers or dispensers:
• Reconnect the water supply and turn on supply valve.
• Monitor water connection for 24 hours and correct leaks if
necessary.
• Run 10-15 glasses of water from the dispenser to flush out
the system.
• Restart the ice maker by lowering the ice maker arm.
• Discard at least the first three ice harvests.
After a long vacation or absence:
• Reconnect the water supply and turn on supply valve.
• Plug the refrigerator back in and reset controls (see page 2).
• Monitor water connection for 24 hours and correct leaks, if
necessary.
For dispenser models, run water through the dispenser for at least
three minutes with the filter bypass in place, then install water
filter (see page 7).
• After installing the water filter, run water through the
dispenser continuously for at least two minutes, or until water
runs steady. Initially you may notice a one to two minute
delay in water dispersal as the internal tank fills.
• Restart the ice maker by lowering the ice maker arm.
• Discard ice produced within the first 12 hours (at least the
first three harvests).
p
reparIng to
Excessive Weight Hazard
Use two or more people to move and install refrigerator.
Failure to do so can result in back or other injury.
• Follow the above instructions for long vacations/absences,
through step 7.
• Secure all loose items such as shelves and drawers by taping
them securely in place to prevent damage.
• Tape the doors shut.
• Use an appliance dolly when moving the refrigerator. Always
truck the refrigerator from its side or back - never from its
front.
• Be sure the refrigerator stays in an upright position during
moving.
14
m
ove
WARNING