Loc8tor Lite Mode D'emploi page 5

• Release button – Loc8tor will beep to confirm start of
registration and status light will flash rapidly. Tag will
complete registration process.
• Once registered Tag and Loc8tor will beep and flash
once.
Repeat process for up to 4 Tags, assigning each Tag
to a different button. Each of the four Tags when being
located will beep differently to help identification.
3. ATTACH TAG
Adhesive strips: Best used when attaching to a clean,
dry, hard, flat surface. Peel off backing to attach.
Sticky tabs are not permanent but increase their bond
with time. Ideally leave for a minimum of 10 minutes.
Strongest bond after 24 hours. To remove insert flat tool
under Tag and gently twist to prise off.
Key ring loop: Use to attach Tag to items such as key
ring, bags, mobile phones etc. Push loop through the
Tag hole and then pull ring through the loop.
5