Installation - oneConcept 10033098 Mode D'emploi

INSTALLATION

Please note: A gap of at least 60 mm from the floor and 100 mm to any
window frame above must be maintained. Minimum distance to any corner
must also be 100 mm. To the ceiling, the distance should keep 650 mm at
least. Always check that the radiator is horizontal. The radiator must Not be
installed below a permanent wall socket.
1. Put the wall brackets on the wall as a guide ruler (please make sure the
holes at parallel level) , Then mark the position of the holes
2. Drill holes on the wall with 8-mm drill bit and insert the plastic wall plug
3. Fasten the hanging rack on the wall with the screws, make sure the
hanging rack is in correct direction
4. Insert the heater body of the bottom to the hanging rack first and then
push the heater body to be hooked on the whole hanging rack
WARNING: Risk of personal injury
When drilling holes, always check to ensure there is no wiring,
pipework, etc. in the area to be drilled.
Before plugging in the unit make sure the radiator is properly attached to the
wall. Otherwise problems can occur.
EN
17