Jandy Pro Series ePump + SVRS Manuel D'installation Et D'utilisation page 15

Jandy Pro Series ePump
®
Lid with
Locking
Ring
Seal
Blue Pressure Test O-ring
Figure 9. Blue Pressure Test O-ring in Lid Assembly
Lid with
Locking
Ring
and
Seal
Blue
Pressure
Test
O-ring
(Note: Discard
after pressure
test is complete.)
Pump
Debris
Trap
Basket
(Inside
Pump)
Figure 10. Exploded View of Pump
|
+ SVRS Installation and Operation Manual
™
ENGLISH
WARNING
ELECTRICAL SHOCK HAZARD
Turn off the pump and the main breaker in the pump
electrical circuit before starting the procedure. Failure
to comply may cause a shock hazard, resulting in
severe personal injury or death.
WARNING
ELECTRICAL SHOCK HAZARD
Due to the potential risk of fire, electric shock, or
injuries to persons, Jandy Pumps must be installed
in accordance with the National Electrical Code
(NEC ), all local electrical and safety codes, and the
®
occupational Safety and Health Act (OSHA). Copies
of the NEC may be ordered from the National Fire
Protection Association, 470 Atlantic Ave., Boston,
MA 02210, or from your local government inspection
agency.
In Canada, Jandy Pumps must be installed in
accordance with the Canadian Electrical Code (CEC).
Replace Blue O-ring
1. Turn the lid with locking ring upside down and
place it on a stable surface.
2. Place the blue o-ring on the step located ¼" from
the bottom of the lid. See Figure 11.
3. Make sure that the o-ring is properly seated. It
helps to "place" the o-ring on the step rather than
to "roll" it on. That prevents it from rolling off.
NOTE The blue o-ring sits approximately ¼" away
from the seal. See Figure 11.
4. Carefully install the lid, making sure that the blue
pressure test o-ring sits in the housing without
"binding" or "rolling" off. Use soapy solution if
needed for lubrication.
5. Following the markings on the locking ring,
align 'START' markings with the ports and turn
clockwise until 'LOCKED' markings align with
the ports. Do not tighten past the 'LOCKED'
marking.
Upside Down View of
Bottom of Lid
Groove where
Seal is Seated
Figure 11. Placement of Blue Pressure Test O-ring
Page 15
®
Step where
O-ring is Seated