Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
How to Install Your Range Hood
When you've completed all the preparation steps, you're
ready to install your range hood.
1. Test the Unit
Plug the unit into an outlet and press the touch panel to make
sure that the unit is working.
IMPORTANT: If the range hood is not working properly,
please contact us immediately (1-800-929-0168 /
info@hauslane.com).
2. Uninstall the Range Hood's Bottom Cover
Remove the baffle filter from the hood by pushing the filter
knob inward. Slowly pull the filter down and remove gently
from the range hood. Then, remove the bottom cover by
carefully unscrewing the eight screws as shown.
3. Jack Up the Hood
If you are not removing the range, place the plywood (30" x
24") over the range / cooktop to avoid possible damage. Put
the cabinet jacks on the plywood and place the second piece
of plywood over the two cabinet jacks. Using the cabinet
jacks, lift the hood into its position under the cabinet. Ensure
that the adapter and power cord enter the cabinet openings
and that the power cord is not pinched between the hood
and the cabinet.
If you do not wish to use a cabinet jack, you will need three
people. Have two helpers holding the range hood in place
while the third person inserts the screws to mount the range
hood. For cabinet jack operation, please refer to its manual.
UC-PS18 USER MANUAL
Screws
4. Screw It Into Place
From the bottom of the hood, carefully insert the mount-
ing screws (AA) with washers into each of the pre-drilled
mounting holes in the range hood. Start with the front left,
then front right.
After the screws are in place for the front mounting holes,
work on the rear left, then rear right. If you feel that you
need to install the range hood more securely, you can use
the additional two mounting screw holes in the front/cen-
ter.
TIP: To easily reach the rear mounting holes, use an
extension tool for the power drill.
AA
Optional
11
Publicité
Chapitres
Table des Matières
Dépannage
