2.5 Scope of supply
Cordless drill driver and cordless impact drill driver A18 and ASB18 complete with:
1 cordless screwdriver
1 quick-release chuck
1 rechargeable battery 4.0 Ah for product no. 91C801, 91C821, 91C901, 91C921
1 rechargeable battery 5.5 Ah for product no. 91C801, 91C821, 91C901, 91C921
1 additional handle
1 quick-release bit holder
1 rechargeable battery for product no. 91C801, 91C821, 91C901, 91C921
1 belt clip
1 operating manual
1 folder "Safety instructions"
2.6 Use according to intended purpose
The drill drivers and impact drill drivers (A18 and
ASB18) are suitable for drilling without impact in
metal, wood, plastic and similar materials as well as
for screwing and tapping.
The impact drill driver (ASB18) is in addition suitable
for impact drilling in concrete, masonry, brickwork and
stone.
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
In order to use the appliance as intended, you must
comply with the operating, maintenance and repair
instructions specified by MAFELL.
Corrective maintenance work must be carried out by
MAFELL authorised dealers or MAFELL customer
service stations.
The safety instructions applicable in the respective
country of use as well as other generally recognised
rules pertaining to safety and occupational health
must be observed.
Unauthorized changes to the appliance shall rule out
any manufacturer liability for damages resulting
thereof.
Only use original Mafell / CAS rechargeable batteries
and accessories.
3
Safety information
Danger
Electrical appliances may be
dangerous if used incorrectly.
Therefore, always observe the
safety instructions summarised in
this chapter and the safety
regulations applicable in the
respective country of use!
3.1 Safety instructions for all types of work
- Wear ear protectors during the use of impact
drill drivers (machines with the designation
ASB). Exposure to noise can cause loss of
hearing.
- Make use of the additional handle supplied
with the appliance. Loss of control can lead to
injuries.
- Always hold the appliance by the insulated
gripping surfaces when carrying out work
during which the bit may hit concealed power
lines. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
3.2 Safety instructions for the use of long drill
bits
- Always start drilling at low speed and with the
drill bit in contact with the workpiece.
- On no account may you work at a speed that
exceeds the maximum speed permitted for the
drill bit. At higher speeds, the drill bit can easily
-19-