Exploded View Aqualine 3 Kw; Mounting Instructions; Unpacking And Installation Preparation - FAIE AQUALINE 3kW Mode D'emploi

2.2. Exploded view Aqualine 3 kW

1
4
3
1. Thermostatic plate with regulation thermostat and safety thermostat
Safety thermostat with manual reset, temperature limit at 60°c and 25 Amps cutting capacity (replaced by a PTC sensor and a digital thermostat
on the Aqualine with digital control box)
2. Large protection cap in polyamide
3. Heating coil
Voltage: 230 VAC, single-phase.
Power: 3000 Watts.
Heating element formed in spiral with ultra low wattage density (7,5 W/cm²) and Incoloy 800® stainless steel protection
4. Support base in Polyamide.
5. Stainless steel heating body
6. Wet rotor pump WiloStar Z25/6
Voltage: 230 VAC, single-phase
Frequency: 50 or 60 Hz
3 running speed.
Flow rate in the enclosed table
Power input speed 1 : 49 W
speed 2 : 74 W
speed 3 : 99 W

3. MOUNTING INSTRUCTIONS

3.1. Unpacking and installation preparation

Make sure you have the following components and accessories before disposing of the packaging material:
For a correct installation use the spare parts and accessories delivered with the Aqualine.
1. Heater Aqualine (with or without control box depending the model)
2. Connection kit
3 Air bleed valve
1 Antireturn valve
1 Overpressure valve
1 Counter fitting
1 Union fitting
Last update 10 12 2018
USER GUIDE
AQUALINE
3. Fixation kit
2 aluminum brackets
4 screws M 6
4 fixation screws pin M8
3kW
2
5
6
4