Grille Panel; Step 12 Install Center Trim Strip; Step 13. Adjust Door Swing - Monogram ZKBSN720NSS Instructions D'installation

STEP 11B INSTALL STAINLESS STEEL UNIFIED GRILLE FRAME
Two people are required to install the Grille Panel.
• Align the extruded holes on the unified stainless steel
grille panel with the leftmost hinge. Drive 3 screws
through the hinge and into the panel. Drive 3 screws
through the rightmost hinge and into the panel. Repeat
for the center hinges.
• Grasp grille panel at the center and pull down to close.
The panel should align evenly with the side of the door.
NOTE: To adjust the grille panel backward or forward,
loosen the 2 attachment screws on all 4 hinges. Slide the
grille panel outward or to the back. Tighten the screws.

STEP 12 INSTALL CENTER TRIM STRIP

• Open doors fully.
• The case trims should be evenly aligned top
to bottom with a slight gap between them.
• Starting at the top, press center u-shaped
trim strip (D) over the inside case trims of
both refrigerators.
• Continue pressing trim until you reach the
bottom of the case trims. The trim should
align with the top and bottom of case trims.
31-1000414 Rev. 1
INSTALLATION INSTRUCTIONS

Grille Panel

Case Trim
15
Attachment
Screws
U-Shape
Trim