Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Source language: German
Explication of warning symbols
Safety instructions
Product information
General hazard
This symbol identifies information that is of vital importance for protecting
your health and safety. Disregarding this information may lead to health
impairment and injuries.
This symbol identifies information that is of importance for the technically
correct functioning of the system. Disregarding this information may result in
damage to the device or to system components.
ATTENTION!
Burns hazard!
• Read the operating instructions in full before starting up and follow the
safety instructions.
• Keep the operating instructions in a place where they can be accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health and safety and ac-
cident prevention regulations.
• The dispersion tool may heats up during operation. In particular in the processing
of hot medium, the tool must be cooled before it can be removed from the drive.
• When in operation the dispersion tool can become hot. If the dispersion tool is
not inserted into the drive flange correctly or the medium is hot, it can become
extremely hot.
• Wear your personal protective equipment in accordance with the hazard category
of the medium to be processed. Otherwise there is a risk of splashing and evapora-
tion of liquids; body parts, hair, clothing and jewellery getting caught.
• Use the dispersing tool always inside the stirring vessel.
• Never run dispersion tools dry, as the gasket and bearings will be destroyed if the
tools are not cooled by the medium.
• Rapid temperature change (thermal shock!) can destroy the hard metal sealing
surfaces of the dispersing tool S 65-KG HH.
• No liquid may get into the drive unit of the disperser.
• The work has to be interrupted immediately if you notice unusual noise. The bear-
ings and the seals must be controlled, and replaced if necessary.
• Note the operating instructions of the disperser unit.
• Abrasion of the dispersion equipment or the rotating accessories can get into the
medium you are working on.
• If a dispersing element is damaged, e.g. with hair-line cracks, chips or bent rotor/
stator teeth, it must not be used.
• The dispersing tool consists of a shaft and a generator (stator/rotor). The shaft carries
the marking S 65 KG-HH, where KG stands for the ball bearing and HH for a slide
ring seal made of hard metal. The seal prevents liquid rising up the shaft and destroy-
ing the ball bearing. The top end of the shaft is in the form of a plug-in coupling. The
bottom end of the shaft carries a thread for mounting the stator. The shaft - running
in ball bearings- carries the rotor.
Content
Explication of warning symbols
Safety instructions
Product information
EN
Page
7
7
7
8
8
8
9
10
10
10
7
Publicité
Table des Matières
